Same-security-traffic permit inter-interface
Ok here is the cleaned up config of the Standby 5510, I will post the primary 5510 later. And then During a failover test I have console cable plugged in to the standby, the active light goes green but I am unable to ping anywhere beyond the device itself. After high availability failover wizard I cannot ping the standby units inside interface of 192.168.100.242 which I am assuming is normal. When I pull the power of the primary the amber active light on the standby unit turns green but no connectivity is restored, meaning I cannot get internet, etc. Whats interesting, is I just did another show failover minutes later and its not showing failed, nothing has changed that I am aware of.
#CLEARING XLATE ON CISCO ASDM 5.2 UPDATE#
Stateful Failover Logical Update StatisticsĪnd here is show failover from the standby unit Interface outside (xxx.xxx.38.148): Normal (Waiting) Interface outside (xxx.xxx.38.147): Normal (Waiting) Interface Poll frequency 5 seconds, holdtime 25 seconds
Unit Poll frequency 1 seconds, holdtime 15 seconds A "show failover" show that the inside interface of the standby unit is "failed" įailover LAN Interface: failover Ethernet0/3 (up) I have gone through the high availability wizard via ASDM, and everything seemed to complete ok with out any issues. We have a pair of 5510's set up as Primary/Secondary failover pair.
0 kommentar(er)
